Free shipping worldwide
Easy returns within 30 days
Rated ⭐4.8/5 by our clients
Free shipping worldwide
Easy returns within 30 days
Rated ⭐4.8/5 by our clients
Feed the strap through your jean loops as usual, then line up both buckle prongs with the same pair of holes. The two rows should sit parallel across the waistband. If one prong pulls diagonally, unfasten it and start again with the next matched pair.

For this look, try our Double Grommet Belt (4.93/5 from 15 customer reviews).
Measure the inside height of your narrowest loop and compare it with the strap width. A belt covered in eyelets may give several fastening choices, but the tail still needs to reach a keeper. Check with the jeans at your preferred rise. A belt that fits your waist may feel quite different at hip level.
Wear a cropped tee and black jeans to highlight the two rows of metal. With pale denim, try a charcoal tee to repeat the strap colour above the waist. If you prefer less hardware in view, leave a relaxed shirt untucked at the sides. Check the buckle while seated before choosing the final pair of holes.
Put your jeans on and empty the pockets before doing up the belt. Thread the free end through the buckle frame and lay the strap flat. Lift the two prongs together and let them fall into holes directly across from each other. Pull the tail through the keeper, then slip your hand into a front pocket. The belt should hold its position without pulling the pocket mouth open. If the waistband puckers all the way around, move out one pair of holes and check the jeans themselves for fit.
Lay the belt on a table and fasten it off the body. If both prongs go through the same row easily there, the strap was probably twisting inside a loop. Unthread it and start with the smooth face outward. If the prongs fit different rows even on the table, inspect the buckle alignment and compare it with the product photo. Forcing the second prong into the next row puts the buckle on a slant and can distort the eyelet. A different length helps when the right pair lies beyond the usable end of the strap.
With low-rise jeans, measure along the slanted path through the loops, rather than horizontally across your natural waist. A belt bought for that lower position can leave a long tail on high-rise jeans. Try passing the tail through the next trouser loop. If the tip lands between loops and flaps outward, a removable belt keeper gives a cleaner finish. For a dressier outfit, wear the eyelets against dark trousers and leave only a short run showing beside the buckle. For a punk-inspired outfit, position a cropped layer above the waistband and let the two full rows read from the side.
Try the keeper and next loop first. A thick, eyeleted strap doubled back underneath itself can form an uncomfortable ridge. If several inches are still loose, compare the next shorter belt’s usable holes with the hole you fastened today.
Free shipping worldwide with no minimum purchase.
Transactions encrypted and secured by a SSL protocol.
Not satisfied with your purchase? Return your order for free within 30 days.
Our after-sales service is there for you from Monday to Saturday.